Buy Eurotherm PID Temperature Controller, 48 x 48 (1/16 DIN)mm, 2 Output Relay, 85 → V ac Supply Voltage /CC/VH/ENG/F Browse our latest. Find great deals for Eurotherm I Temperature Controller With Mounting Bracket. Shop with confidence on eBay!. The i/i are compact high performance 4 digit units for measurement Model i: 48W x 48H x D mm. Display: .. Modbus®, Eurotherm ASCII.
|Published (Last):||8 March 2016|
|PDF File Size:||1.97 Mb|
|ePub File Size:||6.71 Mb|
|Price:||Free* [*Free Regsitration Required]|
The following safety symbols are used on the controller: Spring the panel retaining clips eurtherm place. The benefits of two-leg versus three leg power control, in three phase heating applications Download here. Press and 65 Instrument list Eurotherk to select a parameter to change the setting.
Use a 2 minimum of 0. Ensure that the installation complies with local wiring regulations. Where condensation is likely, for example at low temperatures, include a thermostatically controlled heater in the cabinet. Take particular care not to connect AC supplies to the low voltage sensor input or logic outputs.
You are now in Edit level. O6 Continued in next column O0 to reach the Access List Heading.
A universal input enables selection of nine internally stored thermocouple types and the PT resistance thermometer. Return for repair Low display range exceeded: Press to step across the list eurothetm. Two relay outputs are configurable for alarms. Keep pressing to increase the value.
All isolated inputs and outputs have reinforced insulation to protect against electric shock. There are three alarm setpoints. New power knowledge white paper.
The first character is the alarm setpoint number, the next three the eurotheerm type, as follows: O6 0 Having selected a list heading, press within a particular list. The display units Display Units 0. Process interlocks, including over temperature furnace limits, are implemented using relay outputs.
Gives access to configuration level. The benefits of two-leg versus three leg power control, in three phase heating applications.
A mild soap solution may be used to clean other exterior surfaces of the product. The logic can be configured as an alarm output or as an alarm acknowledge input.
Repeat for all the parameters you wish to hide or make readonly then return to operator level: Return for repair Power failure. To avoid this, before handling the unplugged indicator discharge yourself to ground. The operator eeurotherm can be customized to present only those parameters that an operator needs to see and adjust. Check input signal High display range exceeded: Alarm 2 BBB or to Press change the setpoint. If the alarm is disabled, or or will be shown.
Electrostatic discharge precautions When the indicator is removed from its sleeve, it is vulnerable to damage by electrostatic discharge from someone handling the indicator.
It’s a community-based project which helps eurothrm repair anything. OP1 will flash when an alarm attached to the logic output becomes true. It may be necessary to fit a filter across the relay output to suppress conducted emissions. It is called the HOME display. Installation must be carried out by qualified personnel.
It will go steady when the alarm is acknowledged but still true. Voltage rating Cleaning The maximum continuous voltage applied between any connection and ground must not exceed Vac.
Universal input selection 2116k configurable outputs Three internal alarm setpoints Heater failure detection Tactile buttons Customized operator interface. Under fault conditions such a supply could rise above Vac with respect to ground and the product would not be safe. High alarm 2 has been selected.
Low voltage supply 2. Eurotherm Controls Limited, Export Dept. This is normally alarm 2 or 3.