ASTM Ea, Standard Practice for Use of the International System of Units. ISO , SI Units and Recommendations for the Use of Their Multiples. ASTM E [ Withdrawn ]. Standard for Metric Practice. standard by ASTM International, 01/01/ View all product details. Most Recent. Find the most up-to-date version of ASTM E at Engineering
|Published (Last):||28 October 2009|
|PDF File Size:||10.2 Mb|
|ePub File Size:||17.61 Mb|
|Price:||Free* [*Free Regsitration Required]|
However, if the use of a trade name is necessary, include the name of the ve. The target course shall be the third course up from the bottom of the test specimen. Hot-dipped – Has r380. Definitions from the Astn Building Code, Building shall take precedence. These materials are manufactured by various companies and may be known as various trademark products.
The wood test deck shall be of such rigidity that it will not twist or distort with normal handling, or vibrate from the wind velocity during the test.
Avoid the use of trade names for the specification of materials. Search Drafting Zone Resources.
Do not apply pressure to the shingle tabs either during or after application. Local wind conditions may differ from the test conditions both qstm intensity and duration, and should be taken into consideration. Also known as hot strength. An example of this would be SAESteel. Plastics suitable for plating are acrylonitrile, butadiene, styrene, polypropylene, and polysulfone.
It is the responsibility of the user to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. No cement, other than the factory-applied adhesive, shall be used to fasten down the tabs.
All materials contained on this site are protected by United States copyright law and may not be reproduced, distributed, transmitted, displayed, published or broadcast without the prior written permission of Genium Group, Inc.
However, you may download material from The Drafting ZONE on the Web one machine readable copy and one print copy per page for your personal, noncommercial use only.
Asgm service condition designation is for protection against wett. In addition, no free portion of a shingle or non-rigid component shall lift so as to stand upright or bend back on itself during the test.
Full details are available upon request from Genium Publishing Corporation. The end point for failure shall be taken as the time at which the sealing feature fails to restrain one or more full shingle tabs, or a locking ear or tab of a lock shingle tears loose or disengages from its locking position or a non-rigid component is damaged so as to affect the performance of the system.
The test incline shall be 2: Secure the shingles at the outer edge of the test panel by exposed nailing to simulate anchoring at the rake edges of a roof deck.
This standard does not purport to address all of the safety problems associated with its use. The cell or room shall be capable of receiving a minimum 50 in. The stand shall be adjustable to setting the test panel at asgm desired slope, at any horizontal distance from the lower edge of ast, duct opening, and at various angles incident to the wind direction.
This method, assisted by experience and engineering judgment, will also prove useful for development work. If a particular type or grade of material lends itself to the fabrication desired, it should be specified. You may not alter or remove any trademark, copyright or other notice from copies of the content.
Dual dimensioning practices are also to be discouraged for commercial applications in new design. When specifying special materials, furnish a more complete description to facilitate procurement and incoming inspection.
It also facilitates soldering and antigalling. If the project engineer should require other service conditions, they should be specified in satm with ASTM standards, as noted above. Enter one or more keywords separated by spaces.
Inspection of parts should be in accordance with ASTM standards. The fourteen remaining items of controversy were resolved and the new document could have been issued in No undercoating is required on steel substrates. This method is suitable for use in specifications and regulatory statutes. Test another panel at the position judged to be most critical on the basis of the awtm three tests.